|
Title: Hopper knife trouble Post by: MarkInAz on April 19, 2009, 11:18:00 PM I'm puzzled here :103- -- My new knife won't fit the Barcrest. The old knife was broken and it didn't looks right either. But I thought all IGT hoppers were pretty much the same. In the photos, one is an S+, the other is the Barcrest. The Barcrest mounting is too low so the new knife won't sit flush, and it has a different screw pattern. The barcrest part number reads 79721903 Rev G 3/97. Is this normal?
Title: Re: Hopper knife trouble Post by: MarkInAz on April 20, 2009, 04:10:50 AM Here's another shot of the two hoppers side by side.
|