|
Title: Bally Alpha M9000 hard Meters Disconnected Post by: Trinidad on December 31, 2013, 08:33:33 AM How to Solve this Error?
Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: harp on December 31, 2013, 08:53:39 AM Did this issue just appear,
Are your Hard Meters plugged in Do you have Hard Meters If no Hard Meters is the Jumper Connector installed Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: Trinidad on December 31, 2013, 02:59:05 PM Did this issue just appear,
Are your Hard Meters plugged in Do you have Hard Meters If no Hard Meters is the Jumper Connector installed. The issue came up after I ram cleared the machine for the first time The meters are plugged in so that would answer questions two three and four I am quite new to bally's so any info would be helpful Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: harp on December 31, 2013, 03:29:40 PM When you where setting up your options there is a section on some OS for Hard Meter configuration if you set this up, RAM Clear again but leave this section alone, don't set
Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: Trinidad on January 04, 2014, 11:42:56 PM Thanks for the help.
I did set it and i believe that it is the problem because the other ballys I set up i didnt interfere in the hard meters setup. I need help with some of the doors. I have one that has the following doors open. MVLSB. I have been able to close all the other doors but the S i dont know. Where is this switch? Also the lights in the belly and coin tray are not lighting. How could i solve this? Thanks for the help in advance. Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: Oscar Pompa on January 05, 2014, 02:29:56 AM M (Main Door),
L (Logic Door), S (Stacker Door), V (Bill Validator Door), B (Belly Door), D (Drop Door). "S" Indicates the electronic switch circuit monitoring the Cash Box Door (Stacker) is open. The following causes apply: door not completely closed due to damage or foreign object, disconnected or damaged switch, or disconnected, damaged or incorrect cable connections. Solution: Insert the cash box completely. Check the door, door switch, or switch cable. Replace if necessary. Ensure the door is closed. Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: Trinidad on January 05, 2014, 09:11:49 AM And where is the Drop Door?
Title: Re: Bally Alpha M9000 hard Meters Disconnected Post by: harp on January 05, 2014, 01:58:56 PM Drop Door Harness comes off P6 on the Backplane Board, the Drop Door is the switch that mounts inside the Machine Stand and is used mostly with On-Line/Monitoring Systems especially when things are collected or stored inside the stand (think coins if still used)
In most instances you will find that the Drop Door Harness has a Jump Wire Connector installed to simulate Closed The pin out for P6 is attached Harp |