|
Title: Help with S+ and DBV200 jamming Post by: nipsmg on February 03, 2014, 02:29:08 PM I have an s+ with a DBV200. I can get it to take at most 2 bills. After that is takes in the bill, the motor pulses back and forth, and it disables until I power the slot down and back up, at which point the last bill inserted is spit out.
Game PROM SP1274, ID023. Validator is DBV-200-B023. Dip switches 7-10 off. See video here: https://www.dropbox.com/s/5e2kzdzxrn0xkd5/Video%20Feb%2003%2C%2011%2013%2051%20AM.mov (https://www.dropbox.com/s/5e2kzdzxrn0xkd5/Video%20Feb%2003%2C%2011%2013%2051%20AM.mov) Any suggestions? Title: Re: Help with S+ and DBV200 jamming Post by: therockinelvis on February 13, 2014, 04:17:11 PM Loosen the 2 thumb screws holding the bvd in. The red lever on the left should be in the up position so that the back of the validator rests in a down position. Once screws are loosened lowere and raise the red lever a couple times to seat it good, then tighten the 2 screws. Validator has to mesh good with cash can.
|