|
Title: IGTSlot: JCM dbv-145ss Connector Wiring Information Post by: classiccars on February 24, 2014, 05:12:40 PM New IGT S-Plus machine to me. It has a JCM dbv-145ss Bill Acceptor installed. It is currently dead, does nothing. The JCM power supply is/was bad. Waiting for replacement to see if this bill acceptor works.
My question is about the wiring going to the unit. It has two Molex connectors. (A 6 pin connector from the power supply and a 14 pin connector.) The 6 pin connector has all six wires installed. The 14 pin connector has only two wires installed. (I beleive pin 8 ((LED+)) and pin14 ((TTL Output 6)) ) Does this seem correct or should there be more wires installed into this 14 pin connector? Is there a place were I can find a wire diagram/schematic for this IGT S-Plus slot that would should the wiring layout for the Bill Acceptor? Thanks Title: Re: IGTSlot: JCM dbv-145ss Connector Wiring Information Post by: poppo on March 07, 2014, 01:57:37 PM I replied to your PM and questions about the wiring.
|