|
Title: IGT Triple Diamond won't boot Post by: byteblaster on March 14, 2014, 10:18:19 AM Hello guys,
I've bought an Igt Triple diamonds. The battery was removed, so I replaced this. It gave the error 61, validator is running. I then unplugged, put the hopper in the machine (which I've left out, the first time I plugged it in) restarted the machine. Now the displays won't turn on and the reels are spinning slow backwards. Any help would be appreciated Greeting gerrit, Amsterdam Title: Re: IGT Triple Diamond won't boot Post by: cowboygames on March 15, 2014, 12:17:46 PM First thing I'd do is remove the hopper again to see if it will at least go back to the 61 error code. You may have a bad hopper in which case I don't think the S+ machine will run without it or a jumper plug installed. Your 61 error code is standard after a battery change. If you get to where that code comes back, you can open the main door, press and hold the white test button located on the frame of the power with(could be front or back) for 2-3 seconds till you hear an audible ding and the error code switches to 61-1. Then close the main door and turn the jackpot reset key once. This is where you might run into a new issue if the hopper doesn't work. You might check the history here on the site for testing and resolving S+ hopper issues. I'm not familiar enough to offer advice on those. Keep in mind your bill validator, if you have one, will require a chip for activation after the battery change also
Title: Re: IGT Triple Diamond won't boot Post by: byteblaster on March 15, 2014, 12:37:52 PM Thank you for the replay, but I don't get the code back. The reels are sometimes spinning backwards,
but most of the time they don't and are standing still. Futhermore the displays won't burn eg I don't get the error back greeting \gerrit Title: Re: IGT Triple Diamond won't boot Post by: cowboygames on March 16, 2014, 02:08:11 AM have you tried restarting the machine with the hopper removed? If you have and the machine still won't get back to the 61 error code then I would check to see if a fuse burnt out when the hopper was installed
Title: Re: IGT Triple Diamond won't boot Post by: byteblaster on March 16, 2014, 06:53:47 AM hi, thanks indeed a fuse was blown, and now i'm back on error 61. I'll look for a solution to resolve that. Do I need a ram clear prom for this issue?
again, thanks gerrit Title: Re: IGT Triple Diamond won't boot Post by: cowboygames on March 16, 2014, 08:09:59 AM Unknown at this point. A programming chip for the bill validator will be needed if you plan on using bills in the machine.
Title: Re: IGT Triple Diamond won't boot Post by: knagl on March 17, 2014, 02:41:28 AM To clear a 61 error, press and hold the white self-test button for a few seconds. The speaker should ding, and the display will change to 61-1.
Next, close and firmly latch the door, then turn and release the jackpot reset keyswitch on the side of the machine. The displays should go blank, the reels should spin, and then the machine should be ready to accept a coin. Title: Re: IGT Triple Diamond won't boot Post by: byteblaster on March 17, 2014, 06:56:50 AM Thank you both for the quick answer, I have the machine up and running, however every so say 5 minutes the 24 volt fuse is blown.
The fuse also blows with the hopper removed I've tried to get the power supply out of the machine, but I can't get it out. Do I have to remove the Bill validator? It seems to be stuck somewhere, removed one screw but I can't get it out. . |