|
Title: Bally EVO with TITO? Post by: flyboy on May 06, 2009, 07:37:58 AM Bally EVO support TITO?
If then how can i connect "Future Logic GEN2" on it? I can find "COUPON" in dip switch on MPU board. :103- Title: Re: Bally EVO with TITO? Post by: Ozzy on May 06, 2009, 11:38:08 AM You set up the printer in your EEPROM config after a full ram clear, it will allow you to choose either Seiko or Ithaca printer in the menu.
cheers O Z Z Y Title: Re: Bally EVO with TITO? Post by: flyboy on May 07, 2009, 01:13:39 AM Thanks OZZY,
But when i on bit 7 & 8 in dipswitch 1, it shows below, PLEASE RESET DIPSWITCHS PLEASE REMOVE CLEAR CHIP PLEASE RESTART MACHINE what shall i do to clear full ram? and could you send me a picture to connect Ithaca printer, i dont have manual. Thanks, Flyboy Title: Re: Bally EVO with TITO? Post by: Ozzy on May 07, 2009, 09:22:59 AM :172-
cheers O Z Z Y Title: Re: Bally EVO with TITO? Post by: elvisc on October 01, 2009, 06:52:05 PM Its possible to send instruction to me?
I have an problem with Gen2 printer on Unidesa machine. I install the software FLI Download and attached the cable to the printer but they don't communicate. I have set the preferences, COM prt and firmware. Where is the problem? Anyone have the schematic for program cable for Ithaca EPIC 950 Ticket Printer? Thanks. |