|
Title: Bally Pro Power Supply Question Post by: tacman on September 21, 2008, 06:27:26 PM foxsslots1
BALLY PRO - POWER SUPPLY QUESTION « on: June 17, 2008, 03:29:16 AM » -------------------------------------------------------------------------------- In doing initial check of bad PRO series power supply - I noticed the large CAP in the middle of the housing (could not read rating) has the normal POS an NEG leads but also a THIRD contact which did not have anything attached to it. I also found some "clippings" which looked like remnants of someone trimming excess wire from axial type caps laying inside under the power supply board. Is there a connection here that I am missing? Blueridgeslots Re: BALLY PRO - POWER SUPPLY QUESTION « Reply #1 on: June 18, 2008, 12:14:35 PM » -------------------------------------------------------------------------------- That lead is not connected, here is a pic, usually only the board is bad, not the other parts unless plain burn up -------------------------------------------------------------------------------- |