|
Title: Replacing CC62 with IDX-10 Post by: idylewild1 on October 19, 2009, 10:22:37 PM Has anyone replaced a CC62 coincomparator with a IDX-10 in a bally gamemaker. I know it takes a personality plu (PP62). I was wanting to build my own if possible. Does anyone have a schematic of the PP62 connector as far as pinout etc. Any help would be appreciated. Thanks
Title: Re: Replacing CC62 with IDX-10 Post by: fanninislots on October 19, 2009, 10:38:36 PM Does your X10 have a set of optics on the back side of the X10 at the bottom?
Title: Re: Replacing CC62 with IDX-10 Post by: Buzz on October 19, 2009, 11:19:21 PM Ron Look in submit a new file. You have been doing this a lot longer than I, but I tape a nickel to every X 10 I get and toss it in the trash.
Title: Re: Replacing CC62 with IDX-10 Post by: idylewild1 on October 20, 2009, 11:27:47 AM Will check for the optics today and let you know. Thanks
Title: Re: Replacing CC62 with IDX-10 Post by: idylewild1 on October 21, 2009, 12:55:00 AM It appears that there is an optics unit on the back. These have a PP16 personality plug installed. Thanks again for any help.
Title: Re: Replacing CC62 with IDX-10 Post by: fanninislots on October 21, 2009, 05:46:55 PM If you can't find The right personalty plug let me know. Ben
|