|
Title: BALLY PRO - 24 VDC - testing hopper motors Post by: FOXSSLOTS1 on October 31, 2009, 02:25:34 PM I have several hoppers that are not working - I tried to hook up a jumper to known? 24 vdc (the coin in/out meters has 24 vdc using the yellow/blue wires and the grey/white is the ground - when I hook up my jumper to the motor - the motor does activate and run for a second or two then trips the fuse. Is there an easier way to test these motors (using the forward/back buttons - motor will reverse but bind going forward) - just trying to narrow my problem to the board or the motor.
Title: Re: BALLY PRO - 24 VDC - testing hopper motors Post by: Buzz on October 31, 2009, 02:40:57 PM Berry remove the knife and see if it jams going forward,
Title: Re: BALLY PRO - 24 VDC - testing hopper motors Post by: stayouttadabunker on October 31, 2009, 03:19:13 PM Quoting FOXSSLOTS1>>>(using the forward/back buttons - motor will reverse but bind going forward)
Contact brushings are shot in the motor I think? Getting caught up in the armature when going forward.... I'd check the motor brakes too. Title: Re: BALLY PRO - 24 VDC - testing hopper motors Post by: FOXSSLOTS1 on October 31, 2009, 04:26:28 PM i stripped the hopper down to its core - there is nothing in the way. they do go forward slowly - will try a good motor to see what happens - seems strange I have 3 bad motors.
|