|
Title: Bill transport assembly Post by: HOGCAT on November 19, 2009, 03:56:33 PM I had a transport assembly that would not transport the bill from the validator to the cash box. The "idler belt" was stiff from sitting for a few years and had a "memory" issue that made it hard in two spots from sitting idle so long. So I took the belt off and boiled it in water for a few minutes. Then while it was still hot worked it in my hand trying to take the 2 bends out. Put it back in the transport assembly and it works fine now!!!
Title: Re: Bill transport assembly Post by: stayouttadabunker on November 19, 2009, 05:29:14 PM "Boiling rubber" on the kitchen stove...my wife would kill you... :208-
Great post HOGCAT !!! kudos super+ to ya! |