|
Title: Bally S6000 Option 61 stuck Post by: reho33 on January 31, 2010, 02:13:49 AM I tried to setup my Bally S6000 so that it would pay from hopper and printer but when I get to Option 61 I cannot change the option with the "Spin" button Yes I have a hopper and yes it is configured. I read the manual but cannot do what it says to change the option 61 -2 (Printer Only). Ideas? Oh, BTW I am using the 2003 mains.
Title: Re: Bally S6000 Option 61 stuck Post by: StatFreak on January 31, 2010, 04:56:20 AM Is the printer currently operating properly? You probably know this, but did you make sure that there were no credits on the machine when you tried to make the change?
Title: Re: Bally S6000 Option 61 stuck Post by: a69mopar on January 31, 2010, 12:18:43 PM Are you trying to do this immediately following a SafeRam clear? there are some settings that can only be changed immediately after a SafeRam clear operation has been performed.
Thanks, Wayne Title: Re: Bally S6000 Option 61 stuck Post by: reho33 on January 31, 2010, 06:28:55 PM No credits on machine and no, I tried this way after the safe ram clear. Should I just try another saferam Clear and the go into the option again?
Title: Re: Bally S6000 Option 61 stuck Post by: a69mopar on January 31, 2010, 06:39:27 PM yes, do a complete clear then...
Title: Re: Bally S6000 Option 61 stuck Post by: reho33 on January 31, 2010, 07:13:10 PM OK, will let you know Doing a full clear did it, thanks
|