|
Title: pulse protocol info needed Post by: botija on February 01, 2010, 08:09:13 AM i need information about PULSE protocol (like a IGT S-PLUS). how it work`s, it is a serial interface?
thanx from argentina- Title: Re: pulse protocol info needed Post by: stayouttadabunker on February 01, 2010, 02:56:01 PM For communications from the S+ MPU to what?
Title: Re: pulse protocol info needed Post by: TZtech on February 01, 2010, 03:39:12 PM Hello Botja
The pulse protocol ia a propreitary IGT protocol on the S+ and PE+ . It is available on most of the older BV's (You may have to change SW or reflash your particular BV ). Because IGT no longer supports this platform the BV vendors are not likely to have sw for this protocol on the latest validators. Normally reffered to as IDO 23. To date I have not found any info wrt the timing of the pulses. The pin listing for J8 where the bv plugs in is as follows 1 Bill ACP Out 2 Bill ACP In 3 +VB 4 GND 5 24VAC 6 24VAC From the schematic it would seem that the BV ACP out is simply a logic H or L to tell the BV to enable or not. Info from the BV is one way only. Ian Title: Re: pulse protocol info needed Post by: botija on February 03, 2010, 12:25:43 PM may can be possible make some kind of adapter to use a id003 o netplex BV, i saw a few of it on internet but are not available in my country( Argentina ), i have trayed to use a JCM WBA ID023 but the problem is the ID023 check the jurisdiction, and the top dollars game only list USA and Canada.
thanx for help. |