|
Title: Cherry Master Help Post by: TastyHoagie on February 04, 2010, 07:28:18 PM Hello,
I have a table top cherry master with screen problems. I am looking to buy this machine but don't know if it is going to cost a lot in parts. I am skilled but was wondering on difficulty level and if any special tools are required. Thanks For the help! TH Title: Re: Cherry Master Help Post by: partytime on February 05, 2010, 02:13:31 AM You need to change the monitor..........
Title: Re: Cherry Master Help Post by: TastyHoagie on February 06, 2010, 02:25:36 AM Thanks for the reply,
I was thinking that.... So I want to go install a square15" LCD flat panel. I am good at fabrication so fitment wont be an issue. Do I take out the whole tube/chassis assemble and discard? Most important what kind of card do I need? Any hot leads on where to get one? Thanks! TastyHoagie Title: Re: Cherry Master Help Post by: partytime on February 06, 2010, 03:51:53 AM Ebay has the cga to vga cards the re is a post on here about it......
Title: Re: Cherry Master Help Post by: Slot Docs on February 06, 2010, 04:16:35 AM you need a CGA for the cherry master and most of the lcd displays are backward compatible which means they should run on CGA mode
but I would check to make sure with the one you decide to by as not all of them will. Slot Docs Title: Re: Cherry Master Help Post by: asgard on June 27, 2010, 02:38:21 AM Hello, I have a table top cherry master with screen problems. I am looking to buy this machine but don't know if it is going to cost a lot in parts. I am skilled but was wondering on difficulty level and if any special tools are required. Thanks For the help! TH You just have to change one of the three color drivers on the neck board, they're so cheap I just change all three (red, blue and green) Title: Re: Cherry Master Help Post by: TastyHoagie on June 28, 2010, 08:01:05 PM Any instructions on driver replacement?I can see um and understand about the tube voltage ...etc Thanks!
Title: Re: Cherry Master Help Post by: asgard on July 01, 2010, 09:10:22 PM The three black transistors on the bottom left are the color drivers, just desolder and replace.
Pic : http://arcarc.xmission.com/Pinball/Web%20Archives/www.Marvin3m.com%20(Sep-08-2003)/pin2000/monitor3.jpg Title: Re: Cherry Master Help Post by: TastyHoagie on July 02, 2010, 12:21:15 AM Thanks for all the help
please see the pic are these the drivers highlighted in red? they on the on the back of the monitor tube correct? sorry for the ignorance Thanks! Mike Title: Re: Cherry Master Help Post by: asgard on July 02, 2010, 12:34:56 AM correct !
Title: Re: Cherry Master Help Post by: TastyHoagie on July 03, 2010, 12:54:28 AM Thank you for all the help the Part # is c1507 (with e19 printed on top) it looks like a small heat sink bolts on to each one any Idea where I can find them I have had no luck, Thanks Tasty Hoagie
|