|
Title: Bally EVO error message Post by: CVslots on February 06, 2010, 04:35:16 PM I'm working on an EVO (Philix the Cat) and keep ending up at the error message "Multimedia Comm Link is Down" Is this connected to the SAS ? :103-
So far I've done a ram clear, replaced the battery and set the DIP switches acording to the manual. Thanks Darrell Title: Re: Bally EVO error message Post by: ruttrunner1 on February 07, 2010, 01:15:50 AM I think the last time I saw that, I just went into the settings and changed SAS to none.
Title: Re: Bally EVO error message Post by: Bobodude on February 11, 2010, 01:48:02 PM I have seen that on my EVO a few times and it ended up being the mother board was not fully seated into the slots. When you push it in, you have to get past the first feeling of resistance and push hard until it won't go in any farther. Hard to explain but it felt like it had a second bottoming out in the sockets.
Title: Re: Bally EVO error message Post by: CVslots on February 17, 2010, 06:39:25 PM Just a follow up,
I learned a couple of things on the this one. First, just because you have a new battery dosn't mean you have a good battery. And you need a good battery to do a Ram clear. SAS is off and Felix is working. Thanks to all who helped. CVS |