New Life Games Tech Forums

Hi,

I found one of these devices in my shop; but, I can't find the instructions. It's for a PE+ board and has a bank of DIP switches. I know that it emulates different CAP PROM'S. I can't remember where I got it either. If anybody knows or has the instruction sheet, I'd greatly appreciate it.

Thanks.

Hope this helps.

Jerry

go straight to heaven. thanks.

I actually need one of those things.  You want to sell it??
Jerry

I could use two of these, is there any way to build them or duplicate the original? I'm guessing they are no longer manufactured?

These were not a "manufactured" item by IGT - this was a home built design. I have seen two versions of these.

The chips used for the Caprom's are no longer manufactured and it is my understanding that if they were that most modern burners could not write to them.
You can however read the contents of one of these chips easy enough.

So subsequently there have been a couple of mods made.

The first was a piggy back contraption and was based on replacing the caprom with a 27c64.
Using the image from a Caprom you burn a 27c64 chip.

Using a 27c64 socket you simply solder the matching pins to a caprom sized socket and insert that where the Caprom goes and then simply plug in your 27c64.
I think however the contents of the caprom is less than 16k.

The second was to load multiple caproms into the memory space (using an offset) and then burning these to a 27c512. 
Then by using a dip switch bank as shown you could then use different address lines of the 27c512 and select which caprom you wanted to use.

So the term "universal" was actually a bit of a mis-nomer - but it did make the availability and changing of caproms a lot easier.

I think that there are pictures of both of these projects on the forum.

Here is the post with the Schematic......

http://newlifegames.net/nlg/index.php?topic=1391.0 (http://newlifegames.net/nlg/index.php?topic=1391.0)

K+ Jay for finding that old thread.  :3-

I have a bunch of old PROMs, new... blank... but they aren't real cheap.

I can also program them too if you have the code you want on them. I can also duplicate existing PROMs as the programmers I have here will also read them.

RJ- I may take you up on that offer.  I'll PM you.

Dose anyone have the Schematic for the prom board with the switch bank. The one on the link is for the prom reader.