|
Title: How to install a payout counter Post by: MikeyB on March 22, 2010, 04:19:54 AM Hi gang!
I am wanting to install a counter on my 1114 to keep track of payouts. Since my machine has a different oem coin mech, I am not using the rejected/over flow counter. So my thinking was to extend the wiring to the switch and some how connect the switch to where it would get hit by flying quarters, but yet the quarters would still make it into the payout tray. Any creative thinkers out there? Any and all suggestions will be greatly appreciated! If you need pictures of a certain area/ item, just let me know. Thanks again, Mike Title: Re: How to install a payout counter Post by: Op-Bell on March 22, 2010, 05:00:23 AM There is undoubtedly a contact on the hopper that closes for every coin out. Use this to operate your counter.
Title: Re: How to install a payout counter Post by: MikeyB on March 22, 2010, 12:32:54 PM There is undoubtedly a contact on the hopper that closes for every coin out. Use this to operate your counter. Duh MiikeyB!!! and here I am, trying to figure out how to set it up where a quarter will hit it.... Thanks Op-Bell!!! |