|
Title: Hi everybody! need some help with a Bally E 1091-31 Post by: vic147 on June 10, 2010, 12:52:57 AM Hi verybody, i just bought my first electromechanical Bally 3 reel slot, i need a few hints, i was looking at the service manual that is posted heare but i dont quite get it
i have a few questions, first it was working well at the shop except that it would not pay guess it was the hopper, when i got it home it stopped working it just starts but the tilt light wont go off! i removed the hoper and found what i think is the reset switch at the bottom of the cabinet, and foun a cable was deattached from the plug can anyone guide me and help me find out where it is supposed to go? i am including some photos. the model is 1091-31 and i think it was constructed on october 1979 I also canot make the side lamps go on also the one on the front glass. is there any manual online for this machine and where can i purchase it? Thank you all for your attention Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: vic147 on June 10, 2010, 01:04:20 AM I am also posting 2 aditional photos of the machine, it would not let me post more than 2 at a time!
thanks in advance Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: result1 on June 10, 2010, 10:54:46 AM http://www.myslotnotes.com/Bally.html (http://www.myslotnotes.com/Bally.html)
look at the bottom of the page - a few files on the old Bally hope that helps Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: vic147 on June 11, 2010, 08:03:29 AM Thankyou very much for the info, i really apreciate it!
Im still looking for the schematics of this machine, everithing is working ok now except the hoper, it just wont pay! Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: result1 on June 11, 2010, 09:33:39 AM yes, page 14 of this shows the circuit information (Standard payout system)
show each sw that needs to be closed - for hopper to pay out. http://myslotnotes.com/okPDF/bally/bally%20em%20manual.pdf (http://myslotnotes.com/okPDF/bally/bally%20em%20manual.pdf) Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: Neonkiss on June 11, 2010, 07:18:16 PM check the zero stop switch.
Usually the rubber stop is missing, causing a no hopper run issue. Title: Re: Hi everybody! need some help with a Bally E 1091-31 Post by: vic147 on June 17, 2010, 06:56:13 AM Thak you gus for all the info it really helped a lot! the thing is the hoper still wont pay and i suspect there is no hoper control board anywhere to be found!
is there someplace i can buy one? and can anyone tellme how to conect it? i found one molex conector with nothing attached to it. im including a photo also a photo of the hopper where the control board is supposed to go i think. can someone advice me on this? |