New Life Games Tech Forums

New to the site so please bear with me. I ave gotten a Sigma model SG 50B and when I plugged in in it says tilt. It also will not take the coins. Don't know if any one has a manual or can help me get it fixed. have attached a picture. Thanks in advance.

If you go to http://www.rudysdeals.com/ free downloads they might have a manual you can download for free.
@ your coin comparator - where your coin is -pull back & forth a few times to seat coin in & try.

What does it say in display on front. Maybe you have to turn reset key.

I see it has a bill acceptor. Does it take bills?

No- Will Not take bills or coins

open front door---turn machine on----red button on l inside push 2 times--
press start 2 times until bill val. comes up---press bet until it shows bill val on.--
you should hear val. cycle.  --turn machine off & back on--close door & it should take bills.

Before you do anything--Are you sure it does not say rams wrong?  If it does turn reset switch on right side .
Then do above.

Thanks- That got rid of the tilt display and it will now take bills-But will still not take coins

Is there a coin in comparator?  If there is try pulling it back several times to seat coin.

No coin in it. Also could you tell me how to get the bill box out on the side of the machine.

You have to have a coin in comparator to take coin. If a token you use token--If quarter you use quarter.

Open door on on side .--on the container that is there--take something like a table knife --slide in front working up & down while pulling out until you feel it release--do same to rear.

I like these old Sigma's. I have a wild tens & a double jackpot.
Only problem is parts are getting hard to find.
If your bill acceptor only takes real old bills you can get a head to go  on acceptor that will
take newer bills from blue ridge @ top of this page.
Ford

see if this helps

here's another attachment.
If you can't open save to desk top & try to open from there.
I'm poor @ this