|
Title: Using UBA on Mark6 Post by: belize on November 10, 2008, 01:16:39 AM Hi Everyone
Can I replace my WBA13's with UBA10's on Mark6 machines ? If yes how ? Does I still need an interface board for the UBA's that I had to use for the WBA Units ( Rs232 interface board ) or ... ? and do I have to use the same port on the backplane ? Any help or comment will be appreciated Thanks Title: Re: Using UBA on Mark6 Post by: thanh lieu on November 24, 2008, 01:07:13 PM Yes, you can, but in this case you must use RS232 beside WBA boby and burn your eprom to new firmware (IDO03). I am not sure about the cable but you can check the pin of them.
good luck |