|
Title: need Scancoin SC3003 repair manual or instructions Post by: elvisc on August 16, 2010, 06:46:12 PM Hi all,
Anyone have an service manual with schematics or repair manual for coin counter machine Scancoin SC3003-SI1. I have one machine that not start motor and I not have any manual of this machine. I don't know where to start watching for the error. Thanks. Best regards, Elvis Title: Re: need Scancoin SC3003 repair manual or instructions Post by: stayouttadabunker on August 16, 2010, 11:20:52 PM Call these guys up,
They might know a bit about your problem...LOL I posted some links below...>>> http://www.scancoin.com/filearchive/getfile.asp?type=1&objectid=74 (http://www.scancoin.com/filearchive/getfile.asp?type=1&objectid=74) http://www.scancoin.com/document.asp?levelid=81&Objectid=601&type=2 (http://www.scancoin.com/document.asp?levelid=81&Objectid=601&type=2) Title: Re: need Scancoin SC3003 repair manual or instructions Post by: elvisc on August 17, 2010, 05:32:51 PM Thanks.
I write an email to ScanCoin without respond. Its holiday time :) I wait for a few days for an respond. Title: Re: need Scancoin SC3003 repair manual or instructions Post by: stayouttadabunker on August 17, 2010, 05:35:02 PM Do the lights on the display come on?
Some machines have a fuse in the back there. I'd unscrew it out and check it. Title: Re: need Scancoin SC3003 repair manual or instructions Post by: elvisc on August 29, 2010, 07:17:49 AM I have found the problem.
Button C was internal broken and the machine were constantly in reset function. I replace the button and work fine again. Anyone know where I can found buttons for this machine. From scan coin I receive the answer that they not sell it separately, they have the complete board or that I send to it for repair. Title: Re: need Scancoin SC3003 repair manual or instructions Post by: stayouttadabunker on August 29, 2010, 01:18:14 PM These buttons are really separate things.
They work by little magnets molded into the rubber that create a closed circuit when depressed. The button board is one piece altogether with the rubber touch-pad overlay on top of the button board. It's possible that there's an accumulation of metal dust from the coins sandwiched in between forming a continuous contact. I'd remove the touch-pad and blow out dust material from under the pad. Other than that, your only recourse is to purchase a new unit as there may be some button board component burned out. Check out the connectors to the button board too - it's possible there just might be a loose connection as well. Title: Re: need Scancoin SC3003 repair manual or instructions Post by: elvisc on August 30, 2010, 01:45:54 PM The contact metal parts insaid the button is broken in two parts.
I open another good button to see insaid. I need new botton and I don't know where to buy it. |