|
Title: bally E-2000 tilt problem Post by: billzel on September 19, 2010, 06:57:58 PM my machine shows tilt and will not reset. i found if i unplug the J1 connector from the r. c. u. board it does not tilt . will accept a coin, reels kick-off and spin but will not stop. does this indicate a problem with the RCU board, if so where might find a new board. if not, where should i look next? thanks bill
Title: Re: bally E-2000 tilt problem Post by: FOXSSLOTS1 on September 19, 2010, 10:54:22 PM what tilt code are you getting? what is RCU?
Title: Re: bally E-2000 tilt problem Post by: a69mopar on September 19, 2010, 11:45:52 PM reel control unit?
W Title: Re: bally E-2000 tilt problem Post by: billzel on September 20, 2010, 12:30:30 AM RCU may be called reel reader control board. no tilt code given
Title: Re: bally E-2000 tilt problem Post by: billzel on September 22, 2010, 04:38:58 PM after reading my manual about 3 times, i realized that you must activate the key switch to get a tilt code. i turned the switch and nothing happened. a closer look revealed someone had wired the switch n.o to n.c. making it useless, after fixing that, i got a 42 code. i moved the #2 reader to the #3 reel and problem moved with it . i guess i need another position reader AS2977-1 with the 5v lamps. can someone tell me where i might get one. thanks, bill
Title: Re: bally E-2000 tilt problem Post by: billzel on September 29, 2010, 03:55:32 PM after replacing 1 phototransistor in the #2 reel reader, the machine works fine. it is amazing what a person can do if they just read the instructions
|