New Life Games Tech Forums

I have tried a RAM Clear Procedure on my machine several times and I cannot get past the last steps....I have read several of the previous posts but I get struck at the end of the procedure. I get all the way to the end...my machine blinks between MACHINE TYPE MISMATCH and DOOR OPEN MB..I know these are normal, but what is the next step??? I close the door but the machine does not cycle...... I turn the JP key and get the menu....The screen reads Cash 0.00 and Credit..0.25..so I know those steps are okay..I set the machine for Upright not Unknown...but I cannot go forward.....Can someone tell what steps go next...???

Did you then put a key chip in, power up until the MPU lights come on, then switch back to the base chip?  It sounds like you only made it half way so far.

 :259-

In agreement with this, it's the missing step !

In Key menu you MUST set " Machine Type "    Slant Top or Upright

All those steps were completed....I read that I should use the chips twice....also when I turned the machine on this morning...the RAM Error appeared and the Sound came on.....Any suggestions????

Check your main battery and try the clear chip again.

I tried your suggestions...I had no luck....then I bought a new board.....did the Clear Procedures...and everything worked fine....Thanks for everyone's ideas and help.