X-Arcade Stick Info

[channelmaniac]

Model: 2 player stick
(Can be PC, PS2, XBOX as they are all the same other than the external connector cable)
Board was labeled MOD-1234 XGAMINGtm
--

Ages ago I scrapped out an X-Arcade 2 player control and turned it into a JAMMA testbed for repairing and testing game boards. When I disassembled the unit I took tape and made little tape flags for each wire and wrote what they were for on the flags. I also marked the harness connector and the board connector with different colors and location of marks to keep the harness and the board location together.

However, I don't remember if the buttons were labeled left to right or from top to bottom. I think left to right.

One big caveat for wireing these controllers is: DO NOT CONNECT THE GROUNDS TOGETHER. The grounds on each connector are ONLY for the wires on that connector. These are forming a matrix and if you connect the grounds together you short that matrix.

JP2: TBSA (these letters are silkscreened on the pc board next to the various jacks)
1 - gnd
2 - 1P Start
3 - Left Pinball Flipper
4 - 2P Start
5 - Right Pinball Flipper

JP3: PMRQ
1 - gnd
2 - P2 Button F
3 - P2 Button H
4 - P2 Button C
5 - P2 Button G

JP4: ONLK
1 - gnd
2 - P2 button A
3 - P2 button B
4 - P2 button D
5 - P2 button E

JP5: ZY1YZ1
1 - gnd
2 - P2 Up
3 - P2 Down
4 - P2 Left
5 - P2 Right

JP6: HEJI
1 - gnd
2 - P1 Button F
3 - P1 Button H
4 - P1 Button C
5 - P1 Button G

JP7: GFDC
1 - gnd
2 - P1 Button A
3 - P1 Button B
4 - P1 Button D
5 - P1 Button E

JP8: VXUW
1 - gnd
2 - P1 Up
3 - P1 Down
4 - P1 Left
5 - P1 Right

JP9: selector switch

JP10: LED / LOAD
1 - LED gnd
2 - LED +
3 - nc
4 - Back Panel button
5 - Back Panel button