Trouble clearing and set up of I Dream Of Jeannie

[BR549 Auto Sales]

I am converting a S2000 machine to a I Dream Of Jeannie, went through the clear procedure, let the 2 amber lights come on 3 times to clear everything. Put the SB chip in annd it comes up for just a few seconds goes to "testing memory" on the display, but then goes blank and it will not get to alarm sound or the "ram error" in which I turn the reset key 4 times, etc. I opened the door and the led lights on the cpu seem to be correct, but the single red led all the way at the bottom of the cpu is steady red. I am using game 1&2 363 SG chips and version 11GXO and me SB is 100037. Any ideas as to what may be the problem here?

Thanks,

David

[Yoeddy1]

If you run the clear procedure again, but throw in a different SB, any change with the behavior?

Jason

[BR549 Auto Sales]

I'll try that now and get right back yo you.

Thanks,

David

[BR549 Auto Sales]

Tried a different SB got the same reults, so I tried another known working cpu and did the clear and when I re-installed my Jeannie SB chip and upon power up I get "system error" Any ideas?

[BR549 Auto Sales]

I am getting "bad eprom crc error" after it goes to "call attendant" after turning the reset key.

[kforeman]

   if you got it to work after swapping the mpu then you already found the problem.  the crc errors are very common when changing boards.  does the error not go away after reset key and white button holding?

[BR549 Auto Sales]

So you are saying to turn the reset key? any certtain amount of times? Then after that to press the white button on the mpu?

[kforeman]

the game should pretty much guide you through it.  open the door and hit the reset key until it displays "press and hold the test switch for 3-4 seconds" or something like that.

[Yoeddy1]

Hi David,

Did you follow the clear procedure to the letter per the attached document, even with the new SB or MPU?

Thanks,
Jason

[BR549 Auto Sales]

I did all of that with a different SB and everything worked fine. Took it out and ran the same procedure with the SB100037 chip and got the same "system error" message again. I am just getting another SB chip, this one must be coorupt, I'm giving up on it.

Thanks for the help though.

David

[BR549 Auto Sales]

moderator, please remove.

Thanks