Raising payout percentage on my S2000 Multi Denom.

[grumpy]

Have a S2000 DD Haywire Multi Denom that is really tight.Would like to raise payout percentage to as high as possible.Have a key chip and understand how to get into the key menu but after that i am lost. I have freinds come over and play my machines but every one is avoiding this machine. Which i think it is a fun machine to play. Need some advice suitable for a newbie to understand Thanks in advance

[stayouttadabunker]

What pair of SG chips are you using?
I may be able to help you.
Also, is this a 2 coin game or a 3 coin game?

[grumpy]

It is a 2 coin game with SG000363 1&2 Thanks Ed

[stayouttadabunker]

The menu tree in slot machines are like the old VCR clock's when you need to set the time so they stop flashing "12:00"  

It takes some getting used to and utilizes a combination of deck buttons, test button, and reset key turns.
Plus, some  of the options are not enabled unless you use a special Keychip or Clear chip to open them up.

You need to keychip your machine with a KEY00031 get into the [7] Key chip config menus
to get at the "7.1.2 Game Selection" which houses the percentage options.

Here's a snapshot of the instructions you need once you performed a keychipping  procedure.

Click on snapshot to enlarge if needed...>>>

[grumpy]

Thank you very much for the info. The machine is running fine and all different denominations are set .All i want to do is set the payback percentage to the same amount on all denominations. I must be getting senile because i do not see any thing that says press this button then press this button and you are done. I guess i will not bother with it.Once again thanks a lot.Ed

[stayouttadabunker]

IGT likes to say: "Use the Change button to screw up your machine's settings so it will be next to impossible to get your machine set the way you want it to."     

They really should write: "Start a new thread on NLG and hopefully a member will help you out because we only want money from big time corporations"     

[knagl]

All i want to do is set the payback percentage to the same amount on all denominations. I must be getting senile because i do not see any thing that says press this button then press this button and you are done.

Read the last paragraph in the document that Bunker posted above, and in particular the last sentence. 

[Foster]

It is not that hard.
I and a few others on here can walk you right through the process but you do need a key chip 31. and no credits on the machine when you are ready to do it.