Sigma " Tilt Meter Cut Check Wire" Error

[gordy]

There is no wire cut to any meter.   How exactly do you disable or bypass a meter?  This customer has no interest in the meters.  It is a Sigma  Nudge machine [reels ]. The " Tilt  Meter Cut  Check Wire " error code will not go away.

[riverratmike]

There is no wire cut to any meter.   How exactly do you disable or bypass a meter?  This customer has no interest in the meters.  It is a Sigma  Nudge machine [reels ]. The " Tilt  Meter Cut  Check Wire " error code will not go away.

I get the same error code sometimes on my SB50. It goes away most of the time and the game will start playing normally.

[Mr. Dinoman]

If it is a SG150 or SG300 (possibly other models to) turn of SW2 post 10

[gordy]

Found it !!!!!    After three months, I noticed the bottom of the large ribbon cable was tilted out just a hair where it attached to the door.  It was caused by the game board door flap that would fold down, put stress on the ribbon cable and caused the cable to tilt out at the bottom.  It had happened so much that the clip that clicks into place that holds the plug tight had become sloppier than an Obama speech. An elastic now holds both clips to keep the connection tight. The door was ripped off and thrown against the wall.

[Jimise]

Yes, I did the same thing! Those doors are a pain in the ass! 

The door was ripped off and thrown against the wall.

[gordy]

Did you get the same tilt message I got ?

[Jimise]

Yes, I have had that message before.
Sometimes those cables can be touchy,Or they get cut/pinched.
It does not help matters when that door keeps hitting the cable!