Need key chip instructions

[Kellyat1111]

I have a slot that the max coin bet should be 45 but is set at 15 please help

[staz]

if your machine is a s2000?????????? here are the basic instructions to clear a s2k machine....but i dont think that will solve your problem to change max credits....... thats sounds more like you will have to change the sb chip to change max credits...... a clear on the machine wont change max credits!!!






RAM CLEAR PROCEDURE FOR BASIC IGT S-2000 GAMES

Equipment:     IGT S-2000 RAM Clear set contains IVC00097 & KEY00017 chips.

1.  Power down game and remove CPU board.

2.  Remove the STEPPER BASE chip U21 (SBXXXXXX) and install the IVC00097 clear chip.

3.  Re-install the CPU board and power game up, once the clear is performed the top two Amber LED's will be lit, this could take up to approx. 20 seconds.

4.  Power down the game and remove the IVC00097 clear chip and install the STEPPER BASE (SBXXXXXX) back into the U21 socket.

5.  Power the game up, and clear the error codes. The first error will be RAM ERROR, to clear this turn the JP reset keyswitch. The next message shows "GAME EPROM CRC MISMATCH",    again turn the JP reset keyswitch to clear. The next message shows "SOME CRITICAL DATA WILL BE LOST" again turn the JP reset keyswitch to clear. The next message shows the following directions "PRESS TEST BUTTON FOR 2-3 SECONDS" and then "PLEASE CLOSE DOOR"

6.  Now the game will initialize and a second error code will appear" CALL ATTENDANT", open the door and the display will show a "EEPROM ERROR". Turn the JP reset keyswitch to clear the error. The next message shows " EEPROM CRC FAILURE" again turn the JP reset keyswitch to clear. The next message shows "SOME CRITICAL DATA WILL BE LOST" again turn the JP reset keyswitch to clear.

7.  Now the game will initialize in game mode and the display will show "CALL ATTENDANT / MACHINE TYPE MISMATCH" this is normal and will only display this until the options have properly been set.

8.  Now power the game down and remove the CPU.

9.  Remove the STEPPER BASE chip U21 and replace will the KEY00017. Power up the game.

10.  When the keychip is complete again the top two Amber LED's will be lit, this could take up to approximately 20 seconds.

11.  Power down game and re-install the STEPPER BASE back in to U21.

12.  Power game up and the display will show [ 7 KEY CHIP CONFIG ] Use the SPIN to enter into a menu, BET MAX to recede out of a menu, CHANGE and CASH OUT to select the value.

          7 KEY CHIP CONFIG
          7.1 KEY CHIP CONFIG I
          7.2   KEY CHIP CONFIG II

          Refer to Options Sheet
          Once completed repeatedly press the BET MAX button to exit key chip menu and initial the game or close door.

13.  Close the door the clear the "CALL ATTENDANT / MACHINE TYPE MISMATCH" error code.

14.  Now you are ready to set the rest of options (to access the option, press the TEST button on the CPU)

[Kellyat1111]

Thank you very much

[coorslight115]

I have a slot that the max coin bet should be 45 but is set at 15 please help

You have the wrong SB chip. What game is it and what Stepper Base chip do you have? No key chip setting will change max coin setting.