IGT S+ Bill acceptor housing (removal)

[B-52BadByron]

What is the best way to take out the bill acceptor housing?  There are 2 nuts between the bill acceptor housing and the right side of the slot machine. There is only about one-half of an inch spacing between the slot machine housing and the bill acceptor housing and the nuts are also about 6 inches to the back, Very tight fit.  All of the other nuts and screws are easy to reach but these last 2 are tough.  OK all of you slot experts, what is the best way to remove these 2 nuts and then replace them?

Thanks in advance

[stayouttadabunker]

A long extension and go through the hole from outside the cash box.

[B-52BadByron]

The holes are blocked by metal riveted inside the bill vallidator housing.  There is no straight way to get to the nuts using an extension.  The only way I can see is with a long combination wrench, this would be very difficult!

[stayouttadabunker]

You need to remove the guts of the cash box first by taking off the 2 small Phillips screws from the front...
Open the cash box door, look all the way into the back wall through two holes.
You will see that there's a phillips screwhead head in each hole there.

[slots4home]

you need to remove the inner chassis usually held in by 2 phillips screws in the back of the chassis, pull out the cash can and you will see them and 1 or 2 screws on the left side remove the inner chassis and use a extension and you gan get to all 5 nuts 2 on the bottom and 3 running up the back side
good luck
Darell

[B-52BadByron]

Thanks guys, it will be a few days before i can use your tips.