Welcome, Guest. Please login or register.
October 14, 2024, 10:56:43 PM

Login with username, password and session length
* Home Help Arcade Login Register
.
+  Forum
|-+  NLG Members who host their own Repair Logs of Various Games.
| |-+  Channelmaniac's Arcadecomponents' Old School Repair Logs (Moderator: channelmaniac)
| | |-+  Atari Games (Arcade)
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: 1 [2] Go Down Print
Author Topic: Atari Games (Arcade)  (Read 43380 times)
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #25 on: April 24, 2013, 01:24:06 AM »

Model: Centipede
Symptom: Dead. Solid white screen.

Board was dead. Data bus line D1 was stuck low on the far side of the 74LS245 latch from the CPU. Replaced 74LS373 at J5 and would play blind but the sounds were off. Replaced bad POKEY to fix audio issues. Replaced bad 74LS289 Bipolar RAM at C8 to fix white screen issue. Board would play, but the archer would not move fully to the left and centipede would get stuck on the left 1/4 of the screen. The board would not pass self tests and would continuously beep. Used a Fluke 9010A to test the board and found RAM range 0500-05FF had a stuck bit. Replaced bad 2101 RAM at K5 and tested board.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #26 on: April 25, 2013, 02:46:05 AM »

Model: Centipede
Symptom: Dead. Black Screen

Board would not read the RAM or ROMs with the Fluke 9010A. Found smeared solder short under ROM at J1. Fixed solder short and replaced ICs B1, C1, F2, H2, J2, J4, and P6 that were damaged by the solder short. Board was still dead, but the CPU was able to read and write to all of the RAMs and read the ROMs properly. Discovered board was missing VSYNC signal. Traced it back and discovered a 74LS163 at IC P4 instead of the proper 82S129 PROM. Programmed a replacement PROM and installed it. Tested board.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #27 on: May 11, 2013, 07:45:13 PM »

Model: Centipede
Symptom: Would not coin up with the correct amount

Replaced bad DIP switch and tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #28 on: September 06, 2013, 02:54:57 AM »

Model: Centipede
Symptom: Dead

Replaced bad ROM socket at J1. Reseated the other 3 ROMs. Tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #29 on: September 06, 2013, 02:55:39 AM »

Model: Centipede
Symptom: Stuck in Reset

Board would boot to the game but constantly reset. Replaced bad RAM at H2 and tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #30 on: September 06, 2013, 08:24:15 PM »

Model: Shuuz
Symptom: Excessive EEROM Retries error. Missing motion objects.

Replaced 28C16 chip. Replaced missing GAL chip at 97N with one programmed with code from the Atari GALery. Tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #31 on: October 20, 2013, 10:42:45 PM »

Model: Area 51/Max Force Combo
Symptom: Will not boot.

Cleaned soda spill from board. Replaced IDE to Compact Flash Adapter. Tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
channelmaniac
Surface mount soldering geek
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 568
Offline Offline

Gender: Male
Posts: 2126


Few things are better than fixing an old game...


WWW
« Reply #32 on: December 30, 2013, 03:09:46 AM »

Model: Centipede
Symptom: Dead. No video.

Board had CPU and ROM activity but no horizontal or vertical sync or blanking signals. Replaced dead 74LS163 at N2 and tested.
Logged

I have too many hobbies! Electronics, gunsmithing, Miatas, arcade games, metal detecting, etc...

http://www.arcadecomponents.com
Pages: 1 [2] Go Up Print 
« previous next »
Jump to:  


If you find this site helpful, Please Consider Making a small donation to help defray the cost of hosting and bandwidth.



Newlifegames.com    Newlifegames.net    Newlifegames.org
   New Life Games    NewLifeGames  NLG  We Bring new Life to old Games    1-888-NLG-SLOTS
Are all Copyright and Trademarks of New Life Games LLC 1992 - 2021


FAIR USE NOTICE:

This site contains copyrighted material the use of which has not always been specifically authorized by the copyright owner.
We make such material available in an effort to advance awareness and understanding of the issues involved.
We believe this constitutes a fair use of any such copyrighted material as provided for in section 107 of the US Copyright Law.
In accordance with Title 17 U.S.C. Section 107, the material on this site is distributed without profit to those
who have expressed a prior interest in receiving the included information for research and educational purposes.

For more information please visit: http://www.law.cornell.edu/uscode/17/107.shtml.

If you wish to use copyrighted material from this site for purposes of your own that go beyond fair use,
you must obtain permission directly from the copyright owner.

NewLifeGames.net Web-Site is optimized for use with Fire-Fox and a minimum screen resolution of 1280x768 pixels.


Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Loon Designed by Mystica
Updated by Runic Warrior
Page created in 0.073 seconds with 20 queries.