Ultra Handle problem

[wadwerks]

Figured I would ask here in case it helps some one else in the future. The handle on my machine does not work. Is there a way to disable it? I tested the optics all seem to work just fine. If I pull the handle down and push the solenoid up it locks in place when handle is returned to upright position. If i insert coins the solenoid will release but when i pull the handle it moves in its full range but nothing happens. Is there a trick to getting the machine to recognize the handle or am I missing something obvious like a dip switch position.

[jbshocks]

I am not aware of a handle disable and if there was I would think it would disable the solenoid.  How did you determine that the optics are good?  I got 2 machines that had the handle wires in the wrong spot.  Did you verify wire colors according to the handle diagnostic sticky?

[wadwerks]

Yea I checked the color code they seem to be in the right spot. I did the diag. test 60305, 306, 307 they all seemed to work when removed from handle so I installed them back into the handle and tested it that way and they still seem to work fine.

[uniman]

Ok, when you incert a coin the solenoid should then energize and draw down the lever attached to it, not release anything. If you look just above the solenoid and to the right just a bit, there is a metal channel piece that looks like an upsidedown U. That should pull down when the solenoid energizes. You can pull it down with your finger and it lock in the downward postion. It then releases when you pull the handle down.

You also can do the same input test (#6) Pull the upsidedown U down and 305 should = 1, 306 = 1, and 307 = 0. Just a 1 inch pull of the handle changes 305 to 0. Then with the handle pulled all the way down 306 = 0 and 307 = 1 only with handle in down postion.
You can go up from 305 up to 306, 307 by pressing spin button and you can go down using the BET 1 button.

So the first question is; does your solenoid pull down the U lever? If yes, run inport test #6 above. If no, check to make sure the solenoid is properly attached to pull down.

[wadwerks]

When I put in a coin the lever lock does release but it never locks back in place I have to push it back by hand ir is like the handle doesn't know its been pulled. I will check to see at what point they change from 0 to 1 and vice versa. Does it have to be an inch down when pulling or just in that general area for the sensor to change? Is there any kind of timing of the switches that can be adjusted or does it just recognize 1 switch open and 2 closed?

[wadwerks]

  Finely it is done got it thanks again you guys have been such a big help. Come to find out that if the lever lock bracket is missing a spring it does not return to the locked position when the handle is down so even if you push it into lock it still doesn't work. When i was testing I found 306 was still at 0 when handle was down so I thought the solenoid would push it back up but it never did so did some looking around and found a spring hanging loose but it was hidden under the cover so I never knew it was there. Once attached the lock lever came up on its own and everything works fine. Its been a lot of work but thanks to all the help the machine I got for cheap that was not working at all is now 100% functional.

[uniman]

Glad to hear it!!
Now that you have troubleshot the machine you know a lot more about it!

[wadwerks]

Yea Im kind of glad I had so many problems right off the bat I do have a good idea of how the machine works now so it should make trouble shooting or modifying it a lot easier now.