Problems after S2000 battery change & clear

[Droz]

Hi, folks

I just had the low main battery message on my S2000 (Triple Double Stars.)  I just pulled the main board, pulled out the old OEM battery and replaced it.  I assume it went well?  Regardless, I continued to perform the RAM clear, then used the Key Chip (31) to reset the machine.  That's where things got odd.  I know I have done this before, when I first got it with no problems.  This time, the farthest I can go is with the Dot Matrix display giving me a 7-Segment Display Mismatch error.  I went through this twice (i think) using both 6-6-3 and 5-5-2.  If I look at the display, I seem to be able to count 6 spaces in the top line, 6 spaces in the middle line and 3 spaces in the bottom line.  Wouldn't that be 6-6-3, then? 

ALSO, I noticed that my denomination panel lights are not ALL lighting up.  I figure that it has something to do with the touch selectable denom feature, which I don't use.  But, if you look at the denom panel, only the upper left quadrant is lit, and the rest is dark.  It wasn't like that before I did the reset.  I am out of ideas on this one.  Is there a setting that I am overlooking?  I have never had these problems with this machine, so I can't believe that there would be a problem.  The only thing I changed on this machine when I got it was installing a multimedia board.  But, everything was working fine until the battery message!

Thanks in advance for any possible help...

D

[Foster]

Get that key chip out and go into denom, touchpad and set the denom so it uses all 4 buttons (1,2,3,4)

[Droz]

Thanks, foster!  I did notice that those 2_4 are disabled.  I did that because I couldn't set those denoms set to 1¢ like I have the machine set up for.  Doesn't matter as long as they are enabled?  Also, does that have anything to do with the 7_segment display mismatch error, or is that an entirely different problem?