Sigma uv1700

[waltervan]

So I picked up a Sigma UV1700 last week $50 as is unseen. I get it home found ti stripped and turned in to a 8-liner. I install a old cherry master I had laying around and power it up to find no picture. I pull the monitor to find it not fully seated in and ofter a nice little push I now have a very nice picture I hook up a credit button and every thing is great nice sound great picture. Over all I cant complain for $50 I got an OK cabinet and stand a very nice monitor a good video converter what I did not get was a DBV or ticket dispenser or hopper but nun are needed due to its for home use. What I would like to do is remove the unneeded buttons what I will need are some blank off for the button holes where can I get some or will I need to make my own?

[kforeman]

i recommend Suzo-Happ for button blanking plates.  i'm not sure that they have one for the Sigma but it is definitely worth a shot. 

http://www.happcontrols.com

[Buzz]

. What I would like to do is remove the unneeded buttons what I will need are some blank off for the button holes where can I get some or will I need to make my own?

I have some chrome plates that I have removed from S 2000 to install multi denom. They are about 1 1/4 inch square with one stud and large washer. They look a lot better than this Pic, If they will work for you, how many do you need?