S2000 multi denom issue

[Foster]

Are you saying you only have one denomination set in 7.1.1.3?
If so then change 7.1.1.3 to all 4 denominations you want to use as well.

[cowboygames]

My reel touch has wiring for a multi-denom button next to the max credit button also and it doesn't work either. It may simply be that IGT didn't modify the harness to eliminate the wiring though they changed the software to not recognize it. At the very least it may take some kind of jumper plugged into the segment display to allow the push button to work. You might could trace the wirind back from the push button to the motherboard to make sure they didn't leave it unplugged or disabled somehow. Worst case? You're stuck with using a touchpad

[Foster]

The wiring for the player buttons do not go back to the motherboard directly.
The harness for the player buttons, Coin handling, LED player Display actually goes to the large connector at the bottom of the door I/O board.

The Door I/O board is connected to the motherboard by a 12 wire harness that goes to the door I/O SENET connector on the motherboard.

[cowboygames]

When you say touchpad harness, do you mean the wide connector that plugs into the segment display?

Well I unplugged the touchpad harness, key chipped the machine, set all my values again, same results................ When I tried again to delete the touchpad buttons in the menu mode, it lets me diaable 2,3 and 4, but not 1? I am setting 7.1.1 denom to .25, 7.1.1.1 accounting denom to .25 and 7.1.1.2 coin denom to .25.
I am setting my 7.1.1.3 player denoms as follows:
player 1   .25
player 2   1.00
player 3   5.00
player 4   10.00

I am setting all of the percenatages to game 1 @ 98.2%

What else could it possibly be?

It is also not showing all of the denoms on the display, just the .25 only

[Yoeddy1]

Wonder if it would make a difference nuking (clearing) the machine and starting from scratch with the touchpad disconnected?

Jason

[cowboygames]

and if I'm reading this and past posts correctly, it sounds like you need a 663 diplay for touchpad games and pushbutton denom games have 552 displays. Might it be a guy would have to switch back to a 552 to get the button to work? Just another thought...

[cowboygames]

Or send me the machine, if I get it working, I'll test it for a couple years and send it back COD

[BR549 Auto Sales]

I'm about to that point................uggggg!

[cowboygames]

Do you have another machine with regular muti-denom setup you can swap the board into for a test?

[BR549 Auto Sales]

Just a Cleopatra 9 line-90 credit, I don't think that will do. it has not got the touchpad behind the reel glass though, it has been replaced with a single lamp socket to light up the denom.

[cowboygames]

You might borrow the 552 diplay from it for a test