Mini photon for S2000 set up any help?

[morspeed]

How do you set up a mini photon for an S2000? I can test it thru 7 segment display test but am not sure how to set it up?
Thanks for any help.

[Foster]

you need to use a key chip.
7.3.1 Controller set it to stand alone (level 1)
7.3.3 is where you set the stand alone values.

If your S2000 is multi-denom you need to set each denom under 7.3.1 to level 1 stand alone or look at a post I made about creating a progressive value for each denom you use.
Note it is for the Spectrum display but the process is the same because I didn't realize that they made a 7 segment progressive device for the S2000

http://newlifegames.net/nlg/index.php?topic=11907.msg103608#msg103608

[morspeed]

Thanks foster, I did not realize it was the same a say the spectrum. I already know about the multi denom programming.  Now the real question, can I run this and a cham II????
Thanks

[Foster]

You can try
cham II as level 1 linked
the 7 seg as level 2 stand alone.

[IFFV68]

Foster knows  his stuff. Nice person.
He was going to install my progressive  with a blind fold but I talked him out of it.
Must admit he's pretty fast with the buttons.
thanks again Foster.

[morspeed]

Just a little tid-bit of information: If you already have a cham II installed then the mini photon works with that automatically when you plug it in. It will read out the same numbers. Pretty nice and easy. I am also sure the way foster said to set it up and can run multiple level progressives one on the cham II and one on the mini photon.