Welcome, Guest. Please login or register.
November 25, 2024, 07:10:11 PM

Login with username, password and session length
* Home Help Arcade Login Register
.
+  Forum
|-+  **Reel Slots** Gaming Machines
| |-+  IGT S2000 and Vision Games.
| | |-+  Battery questions ( again...)		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Battery questions ( again...)  (Read 3871 times)
CYRIL1973
NLG Member 101 to 500 Post
***

Total Karma Storms: 10
Offline Offline

Gender: Male
Posts: 255
« on: November 05, 2011, 10:33:26 AM »
Hi there,

My Vision series gives me some problem:

Main battery low: I changed the coin size one, I bought it new but shows: 2,5 volts... Is that enough?    I changed the green battery as well.

The rumour says there's a third battery in the top box... Can't see any... Where this one would be?

Thanks for your help.

Cyril
Logged
OhioGaming
Contributing Gold NLG Member
Sr.NLG Member 501 to 1000 Post
*

Total Karma Storms: 297
Offline Offline

Posts: 834



WWW
« Reply #1 on: November 06, 2011, 02:31:03 AM »
Main battery is on the MPU board. 2.5V is not enough juice.

New and new old stock (NOS) is not the same.
Logged
Foster
The S2000 GURU
Contributing NLG Member
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 345
Offline Offline

Gender: Male
Posts: 2872
« Reply #2 on: November 06, 2011, 02:44:29 AM »
2.5 volts enough considering the CMOS RAM only requires 2 or more volts to maintain data per device specifications.
RAM uses micro amps in standby mode.

When I swapped the 504 out the button battery tested at 2.4xV and no error from the machine at the time.

I did put the 504 back in a while back forgot to check battery but did not get a battery error from machine then either.
I needed to test a 502 board so I put the 504B and its motherboard in since I knew the board was good other than battery being a bit low.
The 502 was also about 2.3-2.4V at the time it did not error either.
« Last Edit: November 06, 2011, 03:00:44 AM by Foster » Logged
A Slot Machine and Coca-Cola Addict!!
"If it is not broke do not fix it" I keep forgetting that!
cowboygames
Abbys Dad
Contributing Gold NLG Member
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 680
Offline Offline

Gender: Male
Posts: 3916


Happiness in life is a great dog
« Reply #3 on: November 06, 2011, 02:45:02 AM »
Reel Touch machines have a cmos battery in the top box, but I didn't think the vision games did Scratch Head
Logged
CYRIL1973
NLG Member 101 to 500 Post
***

Total Karma Storms: 10
Offline Offline

Gender: Male
Posts: 255
« Reply #4 on: November 06, 2011, 06:31:41 AM »
Hi,

Thanks for your comments.

I was wondering at one one thing... Wouldn't mt coin sized battery upside down? If so, I can understand why it shows low battery...

The picture is awful but good enough to have a look at the battery.

* DSCN1929.JPG (106.06 KB, 533x400 - viewed 436 times.)
Logged
Foster
The S2000 GURU
Contributing NLG Member
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 345
Offline Offline

Gender: Male
Posts: 2872
« Reply #5 on: November 06, 2011, 06:45:11 AM »
Battery in a socket the positive(+) side goes up.
The positive side goes to the left terminal (it is also marked positive (+)
The inside (terminal on the right) is the negative

It definitely looks like either you or your tech reversed the polarity when installing the battery.
Logged
A Slot Machine and Coca-Cola Addict!!
"If it is not broke do not fix it" I keep forgetting that!
CYRIL1973
NLG Member 101 to 500 Post
***

Total Karma Storms: 10
Offline Offline

Gender: Male
Posts: 255
« Reply #6 on: November 06, 2011, 06:53:33 AM »
Thanks for confirming.

My tech must have been drunk  Crazy. I cannot blame him that much as I was there when he did it and I realized his mistake only 5 minutes ago.
 arrow
Logged
CYRIL1973
NLG Member 101 to 500 Post
***

Total Karma Storms: 10
Offline Offline

Gender: Male
Posts: 255
« Reply #7 on: November 06, 2011, 08:35:30 AM »
The battery is now soldered the right way But I still got a Low battery message.

1/ Either 2,5 volts is too low

2/ I need a reset


 Scratch Head Scratch Head Scratch Head
Logged
brianfink
Contributing NLG Member
NLG Member 101 to 500 Post
*

Total Karma Storms: 20
Offline Offline

Gender: Male
Posts: 348
« Reply #8 on: November 09, 2011, 02:32:43 AM »
you should still change the battery at that voltage it probly won't last more than a few months 
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

SimplePortal Classic 2.0.5

If you find this site helpful, Please Consider Making a small donation to help defray the cost of hosting and bandwidth.



Newlifegames.com ™    Newlifegames.net ™    Newlifegames.org ™
   New Life Games ™    NewLifeGames ™  NLG ™ We Bring new Life to old Games ™    1-888-NLG-SLOTS ™
Are all Copyright and Trademarks of New Life Games LLC 1992 - 2021


FAIR USE NOTICE:

This site contains copyrighted material the use of which has not always been specifically authorized by the copyright owner.
We make such material available in an effort to advance awareness and understanding of the issues involved.
We believe this constitutes a fair use of any such copyrighted material as provided for in section 107 of the US Copyright Law.
In accordance with Title 17 U.S.C. Section 107, the material on this site is distributed without profit to those
who have expressed a prior interest in receiving the included information for research and educational purposes.

For more information please visit: http://www.law.cornell.edu/uscode/17/107.shtml.

If you wish to use copyrighted material from this site for purposes of your own that go beyond fair use,
you must obtain permission directly from the copyright owner.

NewLifeGames.net Web-Site is optimized for use with Fire-Fox and a minimum screen resolution of 1280x768 pixels.


Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Loon Designed by Mystica
Updated by Runic Warrior
Page created in 0.169 seconds with 19 queries.