Bally to Cham2+ harness

[Jordan]

Hi,

Does anyone have a bally to Cham2+ harness or know where I can get the sockets to make my own?

[Jordan]

Ok, here is an update for anyone else that needs to make their own harness.

Thanks to Foster he told me what the Cham2+ end of the harness is,

The Cham II+ end is a 2x7 0.100" inch connector, also a header connector.
Your PC uses the same connectors the spacing and connector size is the same:
PATA, Floppy, USB headers are all 0.100

The Bally end is Molex part # 03-09-2040

http://www.molex.com/molex/products/datasheet.jsp?part=active/0003092040_CRIMP_HOUSINGS.xml

You will need .093" Molex male pins for the Bally end & I would use solid wire rather than stranded wire to make your harness.

Jordan

[Foster]

For Harnesses it is best to use stranded wire.
Solid wire can only handle some bending or flexing until it breaks.
I never had a problem using stranded wire for any harness I have made.
The wire stays crimped in the connector even though I cant crimp them the way the proper crimp die would.

[Jordan]

Thanks Foster,

I have not made my harness yet & I will take your word over guy at frys who said they did not have the Molex conector, (which they did after I found it)

Jordan