60 in 1 jamma wiring question

[BR549 Auto Sales]

I have a 60 in 1 pcb and I have a switching power supply and the jamma harness. How do I connect the jamma harness to my existing upright Pacman cabinet? I believe that I have the switching power supply wired correctly, I need a decription as to how to hook the jamma harness to my existing monitor on the Pacman cabinet. I was going to use a seperate cord for the ac on my switching power supply and keep the existing power supply in the cabinet to power the monitor (unless someone knows a better way to do so) I see that there are led lights on my 60 in 1 arcade classics board, which led light should be lit once I apply power to the game? I tried to use a 19" computer lcd monitor at first (which plugs directly into the 60 in 1 board) but the screen said no signal when I powered it up. I would actually rather use the computer monitor if i could, if there is a way to get it to accept the video signal from the 60 in 1 board.

Thanks,

David

[BR549 Auto Sales]

I may have made some progress, I found the pin outs to the pacman connector and have them running to my jamma portion of video wires. I powered the game up and it went through a long sequence of check-ok tests and then it went to a screen that says "service next" at the bottom of a screen of red, green, blue and white squares. Any idea as to what this is?

Thanks,

David

[slotsteve]

just make sure your pac man power supply is not putting any power to 60 /1 . those old pac man boards  get ac from the p/s which is changed to dc on the old p/m board , take your time doing it its not  hard, once you do 1 you,ll   be wiring them in 30 mins tops
steve

[BR549 Auto Sales]

I am using seperate power, the original cabinet power supply for the game monitor and I have the switching power supply powering the 60 in board. I believe I am getting close to completing the main wiring process, but when I power it all up I get a scrolling "verify ok" checklist then it comes to the color bar test and at the bottom of the screen it says "service next" How do I advance from this screen?

Thanks,

David

[slotsteve]

check dip swicth,s  i sent you last book i had with board but it worked here in jammed game there might also be a button  making ,it  putingt in in service mode

[BR549 Auto Sales]

The dip switches are set correctly on the board. So far, all I have wired into the jamma harness is player 1 button, player 2 button, and all 4 of the joystick switches. Do I need something else wired in to get it out of this "service next" mode?

[slotsteve]

check your wires make sure they are on  right lugs sounds like service sw is closed  are you have a ground touching

[BR549 Auto Sales]

do I need to wire the  orange sevice switch wire from the jamma harness to something? Can't tell where it goes. Still stuck on the "service next" screen

[slotsteve]

touch sevice wire to  ground on other side of 1st player start button  quickly   i still  think you got  it stuck in setup some how send me a pic of what you have on screen
buybest@aol.com

[BR549 Auto Sales]

I was a grounding issue, the game is up and running now.

Thanks for the help.