help and advice

[OldReno]

Your high pays are already there, they are soldered at the bottom of the board, with jumpers going to where they should.  What does the magic is the two sets of outboard wiper fingers which make contact with the feed ring after you put them back on.  They are your high pay circuits.  You should be good to go once you run that jumper on the feed....

[mark the spark]

there is more info i have only just sorted.the 50 pay on the hopper had three wires on it colour wise 43 54 and 81
assuming 43 is the 50 pay and can stay on that terminal
81 appears to be 100 feed and can go on the 100 feed at the bottom so 54 can either be 150 or 200 but the terminal at the bottom is 150 but there is no 150 payout so  can
we solder this to the 200 terminal on the bottom left hand side of the board on the 200 terminal

[mark the spark]

thanks once again to all, machine is now running and paying out although there was a problem on the 200 pay where the carriage arm ran into the switch stack
causing the house electrics to trip, her indoors was not best pleased especially as i lied like a cheap watch and said nothing to do with me but after the second time it happened i had to hold my hands up!!!
will now tidy up the wiring on the hopper clean it up and then will be looking for suggestions about repairing/replacing some artwork on the glass

[mark the spark]

thanks to all this project is all but finished just some cosmetic touches when the right materials come along
just the coin in meter not working and had to disconnect the door switch as the mount wouldn`t fit with the hopper
but all small stuff  really so its onto the next project a 742 penny star so will be starting a new thread soon