Need 5 volts from S2000 to power a Mikohm display.

[qbert]

I'm trying to install a ChamII+ stand alone without the separate power supply on an S2000 machine. I need 12 volts and 5 volts to operate the stand alone.
I can get 12 volts for the processor board from the netplex distribution board so that is not a problem.
Where on the s2K can I tap off to get 5 volts to power the Mikohm display?
Pics would help
Thanks
Rich

[idesign]

You don't, the power supply for an S2000 does not supply 5V.

[qbert]

I guess I can pull 110v off of the bottom distribution and make my own 5v source. I just can't believe there no five volt lurking somewhere in the machine.
Thanks idesign for the rapid response.

Rich

[idesign]

110V AC to 5V DC.........Wouldn't it be easier just to buy the power supply and not fry something? 

[qbert]

We are talking cheap and effective, I have a ton of old desktop computer power supplies and I will just use one of them.
Nice smooth 5 and 12 volt DC and there is plenty of room in the cab to mount it.
I thought I could take the easy way out by using existing wiring.

Thanks

[Foster]

Along as the display data and power cable are long enough the cham II+ and its power supply will fit under the BV housing
that is where I had mine and the display was in a topper on the top of the machine.

[qbert]

Thanks Foster,
I put the power supply in the lower case by the BV, made a harness that uses the PC hard drive connector, with long wires to the stand alone box up top.
I mounted the metal stand alone box in the top box because the ribbon harness was too short. The PC power supply works great!
Here is a pic of the 4 reel project so far, I have a few more things to do like put the progressive sticker in the top glass and finish around the display.
Sorry for the poor quality pic.

Rich