WTB Parts to convert an IGT S+ from quarters to dollars

[jasonmichael]

I have the coin comparitor, shelf wheel and coin wheel.  I need the coin head, conversion wire for the comparitor and two little black plastic pieces pictured.  Anyone got them? 

Oh - also I need a $1 decal. 

Thanks!

[David B Fowler]

Try Rudys Steals and Deals

http://www.rudysdeals.com/index.php?route=common/home

He should have what you need. 
Dave

[jasonmichael]

Thanks Fatman!

[RB]

I have the harness, 40mm optic block & a coin head but it is S2000. I think it will fit but doesn't have the high back.

[Buzz]

I have the coin comparitor, shelf wheel and coin wheel.  I need the coin head, conversion wire for the comparitor and two little black plastic pieces pictured.  Anyone got them? 

Oh - also I need a $1 decal. 

Thanks!

Jason This picture you posted, there is just something that's not right with that comparator and coin head. The coin head is correct for a large coin left hand drop, but the compararor in the picture would have to be turned over to match the left hand coin drop and that will put the electrical connection on the opposite side from any large coin comparator I've ever used. Now there was some Dollar right hand drop coin heads made but they are rare. You can take a half dollar head, remove the back plate and using a beanch grinder if you have one and open up the opening wide enough for a Ike dollar to drop through. Using a half dollar head you can use a CC 16 D 24 volt comparator for Dollars.