WTB IGT S+ Bill Acceptor - FOUND! THANKS!

[nipsmg]

I'm looking for a bill acceptor for a IGT S+ machine, and the bill collection box/stacker/whatever it's called.

An image of the interior of the machine is attached.

Thanks.


EDIT: A member has helped me out with this one!  Thanks everyone for your help and recommendations!

[poppo]

FYY, it appears that the black power supply attached to the left side of where the BV transport goes does not have vent slots in it. If that is the case, you need a DBV145. You can use a DBV200, but you will need a different power supply that has vent slots in it as the DBV200 requires more power and the unvented supply can't handle it.  I would go for a DBV200 as it will handle more of the newer bills (except the newer colored $5s and the new $100s. Plus it allows 4 way insertion vice one way of the DBV145.

[therockinelvis]

I would suggest a WBA 12 and change it all. Much more dependable and easier to get.

[rickhunter]

I approve of ^^^^ post.  Get the WBA 13, so you can upgrade to new currency with just a chip switch. You will need a power supply, a WBA transport and head, a WBA Harness, Cash can and a WBA housing to replace the one you have.

[rocky mountain slots]

remember when changing to wba have to cut bezel on bill head or cut door open so the bezel will  fit the door

[nipsmg]

Thanks for the recommendations guys.. I got a really good deal on a DBV200 head, transport, and cash can, so I'm going that route.. Also, it's a plus I don't have to modify.

Thanks Again!

[therockinelvis]

I don't remember modifying anything.

[poppo]

Thanks for the recommendations guys.. I got a really good deal on a DBV200 head, transport, and cash can, so I'm going that route.. Also, it's a plus I don't have to modify.

Thanks Again!

Don't forget to check the power supply. You need the one with vent slots or you will have problems getting it to work properly.

[nipsmg]

I have one of those on the way too!  Thanks!