Welcome, Guest. Please login or register.
November 22, 2024, 02:20:19 AM

Login with username, password and session length
* Home Help Arcade Login Register
.
+  Forum
|-+  Bill Validators and Currency acceptors
| |-+  JCM DBV-45, DBV-145, and DBV-200 Bill Validators.
| | |-+  DBV 45SS problem
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: DBV 45SS problem  (Read 9079 times)
mario
Guest
« on: December 29, 2009, 02:47:35 PM »

I have a igt s+ triple diamond 2 coin quarter slot.Since I have had it I cannot get the bill acceptor to work.It is turned on and the light lites up. the bill will be taken in and then sent back out after a short delay.The head is a dbv 45ss v3.20 with ID 023.The chip on the board is a sp731.Are these compatible to work with each other or do I need something else?Any help is truly appreciated.
Logged
StatFreak
rotaredoM etiS GLN labolG
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 756
Offline Offline

Gender: Male
Posts: 8549


Warning! Spammers will be eaten, with relish!


« Reply #1 on: December 30, 2009, 12:43:48 AM »

Have you tried a $1 bill inserted face up?

The 145 head will only take bills two ways, not four, and it won't take some of the new colored bills, depending on the version (you can't always trust the sticker).
Logged

I found myself at NLG garfield  ..but got lost again on the way home. Scratch Head 2
If found, please email me to myself. Thanks. yes
       Executive member in good standing of Rick's SMAA.                              Ehhh...What's Up Doc?
mario
Guest
« Reply #2 on: December 30, 2009, 12:49:07 AM »

Yes,That is what I have been trying to send through it.I tried quite a few different bills.Just wondering if I need a 200 head or different board chip?Do any of the dips have to be in any certain position?
Logged
StatFreak
rotaredoM etiS GLN labolG
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 756
Offline Offline

Gender: Male
Posts: 8549


Warning! Spammers will be eaten, with relish!


« Reply #3 on: December 30, 2009, 05:32:22 AM »

All of the dip switches on the head should be off.

Have you gone through your settings on the machine? The credit limit and or bill validator limit may be set too low. While you're at it, make sure that the validator is actually enabled (setting 9 = 1  (although this is not really necessary since the light is on and it sucks in the bills.)) In addition, check your denomination setting. If you have the denomination set at $25 instead of 25ยข, for example, the machine will not take anything but $50s and $100s.

Remember that you won't be able to change any settings unless you have 0 credits on the machine.
Logged

I found myself at NLG garfield  ..but got lost again on the way home. Scratch Head 2
If found, please email me to myself. Thanks. yes
       Executive member in good standing of Rick's SMAA.                              Ehhh...What's Up Doc?
brichter
Spaced Alien
Senior Full time Member.
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 440
Offline Offline

Gender: Male
Posts: 2374



WWW
« Reply #4 on: December 30, 2009, 06:56:47 AM »

Hey Stat, it would take $25 bills wouldn't it?


















 wave Crazy Cry Laughing
Logged

Thanks,
Bill
Buzz
Senior Full time Member.
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 1158
Offline Offline

Gender: Male
Posts: 4641



« Reply #5 on: December 30, 2009, 07:56:54 AM »

Mario make sure the transport is installed properly I have found the easy way to check this is loosen the two nuts that hold the transport in, press down on the RED leaver, if the back of the transport moves up, it's not installed properly.  Two ears on the back of the transport MUST be inserted into two slots in the chassis. I seem to have better luck by removing the cash can and then installing the BV. 
Logged

NLGs Motto  " IF IT AIN'T BROKE GIVE ME TIME IT WILL BE "
mario
Guest
« Reply #6 on: December 30, 2009, 02:30:54 PM »

Buzz,I made sure the transport was seated correctly.It was.I used 3 different transports,still the same problem.I used 3 different 145 heads with ID 023.Still the same result.I used 2 different cash boxes.Still the same.When the bill is taken in it seems like it wants to credit up,but hesitates and sends it back out.It seems like the signal is not accepted .Could the power supply be a possibility of being bad?Could sp731 need an ID 022  ?
Logged
fanninislots
Contributing Gold NLG Member
NLG Member 101 to 500 Post
*

Total Karma Storms: 86
Offline Offline

Gender: Male
Posts: 277



« Reply #7 on: December 30, 2009, 02:48:57 PM »

Do you have a set 15 chip? If you do have you used it to turn the BV(9-1). Ben
Logged

a69mopar
647-402-1977
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 600
Offline Offline

Gender: Male
Posts: 3508



WWW
« Reply #8 on: December 30, 2009, 03:09:42 PM »

I have a igt s+ triple diamond 2 coin quarter slot.Since I have had it I cannot get the bill acceptor to work.It is turned on and the light lites up. the bill will be taken in and then sent back out after a short delay.The head is a dbv 45ss v3.20 with ID 023.The chip on the board is a sp731.Are these compatible to work with each other or do I need something else?Any help is truly appreciated.

SP731 type 0,1,4,5,12      BV ID 2.5
I would update to a newer sp chip so that it plays a little faster, I always like sp1271.  I believe that the ID 2.5 was a compatible protocol, but can't remember 100%, age I guess.  I'm sure someone else remembers for sure.
SP1271 Type 0,1,4,5,19 10MHz   ID-023   

Thanks,
Wayne
Logged

         www.GTASLOTS.com      647-402-1977              BALLY S6000 GALLERY
a69mopar
647-402-1977
Global NLG Site Moderator
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 600
Offline Offline

Gender: Male
Posts: 3508



WWW
« Reply #9 on: December 30, 2009, 03:14:49 PM »

Here is the PSR sheet for the sp731 http://www.newlifegames.net/uploads/up/SP731.pdf

Here is the PSR sheet for the 1271 http://www.newlifegames.net/uploads/up/SP1271_-_backup.pdf

I hope these help, someone must have uploaded them recently, how convenient.

W
Logged

         www.GTASLOTS.com      647-402-1977              BALLY S6000 GALLERY
mario
Guest
« Reply #10 on: December 30, 2009, 03:37:07 PM »

Thanks Wayne and Ben for all the info,I did the set 15 procedure again 9 1  25 cents .Still the same problem.I will take your suggestion and upgrade the game prom and  to a 200 head.Hopefully that will do it.
Mario
Logged
fanninislots
Contributing Gold NLG Member
NLG Member 101 to 500 Post
*

Total Karma Storms: 86
Offline Offline

Gender: Male
Posts: 277



« Reply #11 on: December 30, 2009, 04:17:23 PM »

Yes I would upgrade to the 200 head. The 45 head that you have is a dead end as the new bills come out there is no way to up date the old 45 and 145 heads they have no room in the 512 chip. The newer 200 head is a 4 meg chip. I have the 200 head available for $45.00 including shipping and a test 123 chip for $15.00 and live support to get everything up and running. If your interested call me.

Ben
Logged

mario
Guest
« Reply #12 on: December 31, 2009, 07:31:13 PM »

Ben or Wayne,Today I did a game prom ram clear - no problems.I then did a set 15 chip procedure and turned on the bv 9 1pressed the reset got 0 on the display.pressed spin reel 3 times for 25 cent then pressed reset again but 0 only in coins bet- not 9 1 25 on the display.I repeated this several times but the same results.I even did another ram clear and set 15 .Same results.Could the set15 chip be bad I am using or maybe the game prom ?It seems not to be able to set a denomination.Any help would be appreciated.
Happy New Year ,Mario
Logged
Buzz
Senior Full time Member.
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 1158
Offline Offline

Gender: Male
Posts: 4641



« Reply #13 on: December 31, 2009, 09:00:47 PM »

Once you got to the .25 and pressed reset, then got a 0 your done. remove set chip and install SP chip
Logged

NLGs Motto  " IF IT AIN'T BROKE GIVE ME TIME IT WILL BE "
fanninislots
Contributing Gold NLG Member
NLG Member 101 to 500 Post
*

Total Karma Storms: 86
Offline Offline

Gender: Male
Posts: 277



« Reply #14 on: December 31, 2009, 09:24:38 PM »

Mario,

What game chip do you have? If you want give me a call I went through this with hogcat and found a defective game chip


Ben
Logged

Pages: [1] Go Up Print 
« previous next »
Jump to:  


If you find this site helpful, Please Consider Making a small donation to help defray the cost of hosting and bandwidth.



Newlifegames.com ™    Newlifegames.net ™    Newlifegames.org ™
   New Life Games ™    NewLifeGames ™  NLG ™ We Bring new Life to old Games ™    1-888-NLG-SLOTS ™
Are all Copyright and Trademarks of New Life Games LLC 1992 - 2021


FAIR USE NOTICE:

This site contains copyrighted material the use of which has not always been specifically authorized by the copyright owner.
We make such material available in an effort to advance awareness and understanding of the issues involved.
We believe this constitutes a fair use of any such copyrighted material as provided for in section 107 of the US Copyright Law.
In accordance with Title 17 U.S.C. Section 107, the material on this site is distributed without profit to those
who have expressed a prior interest in receiving the included information for research and educational purposes.

For more information please visit: http://www.law.cornell.edu/uscode/17/107.shtml.

If you wish to use copyrighted material from this site for purposes of your own that go beyond fair use,
you must obtain permission directly from the copyright owner.

NewLifeGames.net Web-Site is optimized for use with Fire-Fox and a minimum screen resolution of 1280x768 pixels.


Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Loon Designed by Mystica
Updated by Runic Warrior
Page created in 0.117 seconds with 19 queries.