S2000 bell

[hedgee]

I have a S+ bell and was thinking of mounting it in my S2000 machine.  Can this be done?  And if so where are the connections to be made? 

[Foster]

it should work,
The S+ uses 24VAC and the S2000 uses a pulsed 24VDC
There is a 2 pin connector that is in the wiring harness with orange wire and yellow with brown stripe/tracer wire
if the bell has red and black wires match red to orange and black to yellow/brown

now where you physically mount it I am not sure.  I do not have bell in my S2000 or S+.

[stayouttadabunker]

I have one down in the right corner behind the DBV cashbox...
lotsa room down there.

[OhioGaming]

Backwall to the left side of the backlit controller board almost directly under reel 2. Usually there is a plate there that the controller board and bell mounts too.

[Bettor Slots]

Backwall to the left side of the backlit controller board almost directly under reel 2. Usually there is a plate there that the controller board and bell mounts too.

Ken's correct as always    ....that is exactly where it is suppose to go...they're are pins there to mount to on the back wall and be careful of the green ground wire in that location as you should temporarily remove it to mount the bell and then of course remount the ground back in it's same location to keep your machine happy