IGT S reset button

[B-52BadByron]

Does the IGT S slot have a rest button?   If so where is it located?  If not how are codes reset?

Thanks

[stayouttadabunker]

I don't really know about the S slot but have you looked behind the power flip switch box?

[Buzz]

Byron  The only S machine I ever had the reset was right next to the power switch ( lower left )

[B-52BadByron]

Found it!  The reset switch is on the front left side in the center of the MPU board housing.  It is in the front middle of the housing, hidden between 2 of the 4 wire bundles that are also in front.

[Buzz]

I am maybe talking out my butt here, but it sounds like you don't have a S but rather a older S+.  A picture here would clear it up.  As I recall a S has the MPU to the rear of the hopper and does not have a Mother board ( all connections to MPU are made via  molex plugs ) Older S+  MPU is mounted to left side of hopper. 

[B-52BadByron]

Buzz, you could be right that it is an older S+.  This is the first one of these machines that I have owned.  I will take some pics and try to upload for you to see.  There is no bill validator and I am wondering if this machine is what intermediate glass fits. 

[blueridgeslots]

You just have a Non Imbedded S Plus, as far as being an Intermediate cabinet, that just depends on the width, they are 3" narrower than a standard wide body, so if the glass from your S-2000's are the same width, then it is a wide body, if 3" narrower than it is an intermediate, all intermediates are Non Imbedded, the wide body can be either way, Imbedded or Non Imbedded, all glass from S, S+ to S-2000 is the same width in wide body

[B-52BadByron]

These are the photos of the machine.

[B-52BadByron]

One more photo.

[blueridgeslots]

Yes, that is an Intermediate, btw, we have Brand New 9" Award Glass for 3cm Haywire for that cabinet

[knagl]

...and it's an early S+ (not "S").